Media set lever: .............. Used to raise or lower the pinch rollers during the loading or unloading of media.
Pinch roller hold-down force switching lever:
Used to switch between the two pinch roller forces (strong and weak).
AC line inlet: ................... Inlet where the power cord is connected.
Media stocker: ................ Used to carry roll media and ensure its proper rotation.
Stock rollers: ................... A media roll is placed on these rollers.
Media lock: ..................... Used to prevent the stock rollers from rotating when the media roll has been placed
on top of them. The media lock ensures that the media is pulled straight out from
the roll.
USB interface connector:
Used to connect the plotter to the computer with a USB interface cable.
Serial interface connector:
Used to connect the plotter to the computer with an RS-232 serial interface cable.
To Next Page
Loading...
