FC7000-UM-251-9370 2-3
2. PARTS NAMES and FUNCTIONS
2.2 Assembling the Plotter
FC7000-75 (desktop model; stand not provided but is available as an option)
When the FC7000-75 is used without a stand, the media stocker bracket is attached directly to the plotter.
The media stocker is made up of the following parts.
ATTACHING THE MEDIA STOCKER
(1) Fasten the media stocker brackets to the left and right inside surfaces of the plotter unit, using two M4
binding-head screws for each media stocker bracket.
(2) Insert an M4 screw in the second hole from the front side of the plotter.
• Check that all of the screws used for fastening have been tightened. The media
may not be fed correctly if even one of the screws is loose.
• When installing the plotter, make sure that there are no objects in its vicinity.
Leave a clear space of at least 300 mm around the plotter.
• When the FC7000-75 is used without a stand, the maximum diameter of the roll
media that can be used is 160 mm.
To Next Page
Loading...
