FC7000-UM-251-9370 2-9
2. PARTS NAMES and FUNCTIONS
2.4 Attaching a Cutter Pen
When mounting the cutter pen in the pen holder, push the pen all the way into the holder until its flange
contacts the upper part of the holder and then tighten the screw firmly. To prevent injury, avoid touching the
pen immediately after the cutting plotter is turned on or whenever the pen is moving.
(1) Loosen the pen holder screw.
(2) While pushing the pen holder in the upward direction, push the pen all the way into the holder until its
flange contacts the upper part of the holder.
• When pushing the pen holder with your fingers, the blade tip may be protruding.
Take care not to cut your fingers.
To Next Page
Loading...
