GRAPHTEC FC7000MK2-130 - Adjusting the Spacing between Pen 1 and Pen 2 (2-Pen Model)

FC7000-UM-251-9370 7-29
7. ADJUSTMENT
7.3.15 Adjusting the Spacing Between Pen 1 and Pen 2 (2-pen model)
This adjustment will set the spacing between pen 1 and pen 2.
If you replace the main board, use the following procedure to input the recorded adjustment values.
If you replace the pen block, you must adjust this value using the following procedure.
(1) Enter the adjustment menu (see Section 7.3.6).
(2) Press the MENU key to display the menu shown below.
SENSOR TEST
KEY TEST
PEN FORCE
XY GAIN
(3) Load an A2 (Letter) or larger size sheet of paper in the plotter.
(4) Mount a disposable ink pen (0.2 mm tip size) in both the pen 1 holder and the pen 2 holder.
(5) Set the plotting conditions to the following settings:
Force: 12, Speed: 40, Quality: 1, Tool: Pen
(6) Lower the media set lever to raise the pinch rollers, and then raise the media set lever to detect the
paper size.
(7) The menu shown below is displayed after the media set lever is raised.
ROLL-1 REAR SET>
ROLL-2 REAR SET>
SHEET>
CONTINUE
(8) Press the F2 key to display the menu shown below.
CONDITION 12
40
READY 1
PEN
(9) Press the MENU key to display the menu shown below.
SENSOR TEST
KEY TEST
PEN FORCE
XY GAIN
(10) Press the NEXT key until the menu shown below is displayed.
1/2 PEN POSITION ADJ
DISTANCE ADJUST
2 PEN POSITION ADJ
RM SENSOR LEVEL ADJ
(11) Press the F1 key to display the menu shown below.
PEN 1-2 OFFSET
ADJUST
TEST PATTERN>
PARAMETER SET>