FC7000-UM-251-9370 6-26
6. DISASSEMBLY AND REASSEMBLY
How to reinstall the drive roller
(1) Reattach in the reverse order in which it was detached.
(2) Spread a suitable quantity of Loctite 222 on the two M3L4WP set screws holding the X-drive pulley.
(3) Perform the X-drive belt tension adjustment. (see Subsection 7.2.3).
(4) Spread a suitable quantity of the Shinetu silicon grease G501 on the X-motor pulley.
(5) Move the X-drive pulley and check the tension of the X-drive belt.
(6) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
