GRAPHTEC FC8600-130 - Setting Shape (Pattern) of Registration Mark

5-8
5-9
4
Press the [1] key (MARK SCAN MODE).
MARK SCAN MODE setting screen is displayed.
Supplement
It will return to MARK SCAN MODE setting screen
without changing the settings when you press the
POSITION (
◄
) key (PREVIOUS).
5
Press the [1] key (OFF), the [2] key (ARMS), or the [3] key (AXIS
ALIGNMENT).
MARK SCAN MODE is selected and it will return to MARK SCAN MODE
setting screen.
6
Press the [2] key (POINTS).
NUMBER OF POINTS setting screen is displayed.
Supplement
It will return to MARK SCAN MODE setting screen
without changing the settings when you press the
POSITION (
◄
) key (PREVIOUS).
7
Press the [1] key (2POINT), the [2] key (3POINT), or the [3] key
(4POINT).
POINTS is selected and it will return to MARK SCAN MODE setting screen.
Supplement
It will return to ARMS setting screen (1/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
8
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (1/4).
9
Press the [MENU] key.
It will return to default screen.
Setting Shape (Pattern) of Registration Mark
Preset the shape (pattern) of registration marks to scan.
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.