GRAPHTEC FC8600-130 - When Feeding Long-Axis Media (at Least 2 Meters); Changing the Hold-Down Force; Switching between the Strong and Low Settings

2-14
2-15
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
Media
15 mm 15 mm
Changing the Hold-down Force
The push roller hold-down force must be set to suit the width and type of the loaded media.
Switching Between the Strong and Low Settings
Use the hold-down force switching lever located at the back of each push roller to change the hold-down force.
Raise the lever to decrease the hold-down force (Low), and lower the lever the increase the hold-down force
(Strong).
Supplement
Low hold-down force is the setting for holding the
inside when cutting a very thin films, such as car
film, using 3 or more push rollers.
CAUTION
Low hold-down force cannot be set to the push
rollers at the end.
Hold-down force
Medium
Hold-down force
Strong
Hold-down force
Low