2-12
CHAPTER 2 Checks and Preparation
2.7 Mounting the SD CARD
•
When the SD CARD is inserted, make sure that the card is not locked. If locked, the data cannot be
captured.
•
Please do not remove the SD CARD while accessing to the SD CARD (Device Access display is displayed
in "red" and POWER LED is blinking.). The captured data may be damaged.
•
When inserting the large capacity SD CARD, it may take some time to recognize it.
How to insert the SD CARD
Insert the SD CARD into the SD CARD slot.
When the wireless unit (option) is installed, the SD CARD cannot be inserted.
< SD CARD >
(1) Open the SD CARD protective cover.
Protective cover
(2) Insert the SD CARD until it clicks and is locked.
* Make sure that the SD CARD is not locked.
* Make sure that the SD CARD is not locked.
SD CARD
SD CARD
x GB
Lock
(3) Attach the protective cover into the upper hole and lower hole for the SD CARD protective cover.
Protective cover
To Next Page
Loading...
