2-24
CHAPTER 2 Checks and Preparation
2.13 Removing and mounting each terminal
This section describes the mounting and removing procedure of the Standard terminal and the Withstand
high-voltage high-precision terminal.
The Screwless terminal can be removed and attached in the same way.
When mounting or removing the standard terminal or Withstand high-voltage high-precision terminal,
please make sure that the GL840’s power is turned OFF.
Removing
Pull out the terminal in the direction of the arrow while pressing the lock portion (place) under the Standard
terminal or the Withstand high-voltage high-precision terminal.
(1) Press the two lock portions in the direction indicated by arrows.
Lock portion
Terminal unit
Pull out
(2) Pull the terminal unit out towards the direction indicated by the arrow.
Pull the terminal unit out as shown in the following gure.
1
2
Bottom
Top
To Next Page
Loading...
