2-14
CHAPTER 2 Checks and Preparation
2.8 Installing the Cover (B-578: Option)
This section describes the method of attaching and detaching the Rubber Protector.
To ensure safe and correct use of this device, read this section thoroughly before use.
How to attach the Rubber Protector
•
This cover is dedicated to GL840. It can not be used for other GL series.
•
To remove the battery pack, rst remove rubber protector.
•
In model that has an SD card slot on the right side of the main unit, remove the rubber protector when
replacing the SD CARD in that slot.
(1) Insert the terminal part of the body into the rubber protector rst.
(2) While opening the rubber protector slightly, put the body in it.
To Next Page
Loading...
