2-15
CHAPTER 2 Checks and Preparation
(3) Make sure that the corners and convexities are properly tted and adjust the protector so that there is no
gap.
There is a protrusion (arrow part shown in below gure) on the back side of the rubber protector,
put it into the gap of the body and the terminal part.
Inserting
How to remove the Rubber Protector
(1) Open the right and left corners of the lower part of the rubber protector cover and remove it from the
body.
(2) Push out the body from the back side.
(1)
(2)
(3) When both corners of rubber protector are removed from the body, remove the body completely from the
rubber protector.
•
The thickness of rubber in side of the terminal is thinner.
•
There is possibility to be broken when opened it with large force.
To Next Page
Loading...
