GRAPHTEC GL840 - Page 79

3-3
CHAPTER 3 Settings and Measurement
2. Time/DIV display area
Displays the current time scale.
3. Status mark
* : Appears when neither capture nor replay is in progress.
* : Displayed when saving the captured data in the internal memory (SD1) or SD CARD
(SD2).
* : Appears when waiting for a trigger during capturing and the stop key after capturing.
* : Displayed when replaying the captured data in the internal memory (SD1) or SD
CARD (SD2).
* : Displayed when replaying the captured data in the internal memory (SD1) or SD
CARD (SD2) during data capture or replaying it the data in two-screen (Refer to “(10)
REVIEW” in “3.2 Key Operation”.).
Please do not turn Off the power and do not remove the SD CARD when the status icon indicates other
than “STOP”. The data is damaged, and it will not be accessed.
Please start the operation after making sure that the status mark is switched to "STOP".
4. Remote unit display
This is displayed when the wireless sensor (GL100-WL) or the remote terminal (GLT400) is connected.
: The wireless sensor setting is On and the unit is not being searched.
: The wireless sensor setting is On and the unit is being searched.
: The remote terminal setting is On and the unit is not being searched.
: The remote terminal setting is On and the unit is being searched.
The remote terminal represents the radio eld intensity with four antennas.
5. Device access display (Internal memory)
: Not accessed to the internal memory (SD1).
: Accessed to the internal memory (SD1)
During accessing to the internal memory (SD1), the POWER LED blinks.
Please do not turn Off the GL840’s power while accessing the internal memory (SD1).
The data is damaged, and it will not be accessed.