3-6
CHAPTER 3 Settings and Measurement
13. Alarm display area
Displays the alarm output terminal status.
The number with which an alarm has occurred is displayed in red. The channel with the alarm cause has a
red input value in the digital display area.
14. Pen display
Displays the each channel signal position, trigger position, and alarm range.
Trigger position Alarm range
Stop position
Start position
Rising Falling Win In Win Out
15. File name display area
(1) During data capture
A capture le name is displayed during capture.
* If the ring recording setting is ON, a le name displayed during capture ends with "_RINGx" (x
represents a number) but the actual le name does not include "_RINGx".
In the above gure, if the ring recording is set to ON, the le name during capture will be displayed,
for example, as "<SD1>150302\150302-090930_RING4.GBD" but the actually created le will be
"<SD1>150302\150305-090930_.GBD".
* Refer to “(2) DATA settings” in “3.4 Setting Menus” for details.
(2) During data replay
Information on the time axis of the cursor is displayed during replay.
Time to which the cursor points
Selected cursor
Time difference between Cursors A and B
16. Scale lower limit
Displays the scale lower limit of the currently active channel.
17. Waveform display area
Displays the waveform of the input signal.
18. Scale upper limit
Displays the scale upper limit of the currently active channel.
To Next Page
Loading...
