3-22
CHAPTER 3 Settings and Measurement
Setting Selections available
Illumination /
ultraviolet sensor
(GS-LXUV)
Range [Illuminance] / [Accumulated
illuminance]
2000, 20000lx, 200klx
[Ultraviolet] / [Accumulated
ultraviolet]
30mW/cm
2
xed
Filter None
CO2 sensor
(GS-CO2)
Range 5000ppm xed
Filter None
Adapter for AC
current sensor
(GS-DPA-AC)
Range AC clamp mode AC 1P2W, AC 1P3W, AC 3P3W
[Current] 50, 100, 200A
[Power] / [Accumulated
power]
(20, 50, 100kW) Change in synchronization with the current range.
Filter None
EU
(Scaling settings)
Function Off, On
* When measuring the humidity, “On” is xed.
Meas. Value
Upper limit Set numeric value
Lower limit Set numeric value
EU output Upper limit Set numeric value
Lower limit Set numeric value
Dec pt EU output upper limit x 0.01, x 1, x 10, x 100, x 1000
Select Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy,
Pressure, Flow , Temp, Strain, Brightness, Concentration
Unit (The selections vary depending on the unit selected in the above.)
Arbitrary unit Enter text (Max. 8 characters)
Misc. Annotation text string Enter text (Max. 31 characters)
Inter-
CH Op
Settings
Function Off, On
Operation CH-X (+, -, x, /) CH-Y
Scaling /1000000, /1000, ×1, ×1000, ×1000000
Upper/Lower limit Set numeric value
Dec pt ×1, ×10, ×100, ×1000, ×10000
Select Cur, Length, Area, Volume, Velocity, Accel, Freq, Mass, Energy,
Pressure, Flow , Temp, Strain, Brightness, Concentration
Unit (The selections vary depending on the unit selected in the above.)
Arbitrary unit Enter text
Span
settings
Upper limit Set numeric value
Lower limit Set numeric value
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Line Thickness Setting 1 to 8 dots
Trace setting Off, On
Perform Auto Zero ADJ.
* When using the GS-3AT, the auto
balance is performed.
Press right key to execute.
* This function is not available for the temperature setting.
Reset Auto Zero ADJ.
* When using the GS-3AT, the auto zero
is released.
Press right key to execute.
* This function is not available for the temperature setting.
Accumulated reference temperature
-
20
to +
85
°C
* Available for GS
-
TH sensor only.
Accumulated polarity High/Low
* Available for GS
-
TH sensoronly.
CO2 calibration Off, On
* Available for GS-CO2 sensor only.
Voltage 90 to 264
* Available for GS-DPA-AC adapter only.
Power factor 0.30 to 1.00
* Available for GS-DPA-AC adapter only.
To Next Page
Loading...
