GRAPHTEC midi LOGGER GL240 - Safe Operation and Function Notes

II
Introduction
This GL240 is meant for use in Japan, the US, Europe,Taiwan,China and Korea. It has not been certied
for use under any other country’s radio laws.
The following are each region’s certication marks.
Contains NCC ID:
CCAB15LP4220T2
CMIIT ID: 2015DJ5376
MSIP-CRI-KTM-B-568
Japan
US
Europe
R 003WWA100913
Taiwan
China
Korea
Contains FCC ID: ANSBP3591
CE Mark
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2)this device must accept any interference received,
including interference that may cause undesired operation.
FCC CAUTION
Change or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
4. Notes for Safe Operation
(1) Be sure to use the Graphtec-supplied AC adapter. In environments where there is a lot of noise or where
the power supply is unstable, we recommend that you ground the GL240.
(2) When a high-voltage signal cable has been connected to the main unit’s analog signal input terminal,
avoid touching the leads of the input terminal’s signal cable to prevent electrical shock due to high voltage.
(3) Ensure that the GL240’s power source is positioned so that it can easily be disconnected.
(4) Do not input the voltage that is exceeding the specication of this device.
• If a voltage exceeding the specied value is input, the semiconductor relay in the input section will be
damaged. Never input a voltage exceeding the specied value even for a moment. It will cause the re.
• Have an enough margin from the specication of withstanding voltage when using this device, it have to
consider a noise and change of the measurement voltage.
• Conrm this device is not broken before the input cable is connected to the input terminal.
• Please take care of the static electricity when the connecting the input cables or the thermocouples.
• Do not touch the tip of thermocouples with bare hand after the thermocouples are connected to the
terminal of this device when the tip of thermocouples is not insulated.
The static electricity of a human body will cause damage to this device.
• Do not put the tip of thermocouples to the object which is containing the static electricity when the tip of
thermocouples is not insulated. The static electricity of object will cause damage to this device.