3-79
CHAPTER 3 Settings and Measurement
(9) Text input
Related to text input operations such as annotation, EU (scaling) unit and captured data le name input.
<New folder creation>
(1)
(2)
Operation mode Description Operation method
(1) Text input A Upper case alphabet mode When the cursor key is moved to the uppermost part,
operation can be selected using the left/right key (
).
After selecting an operation, use the down key (
)
to move
the cursor to the desired character.
Use the Fast forward left and right (
) keys to move the
cursor on the selected characters.
a Lower case alphabet mode
0 Numeric mode
+ Symbol mode
Delete mode
Insert mode
OK Finalize mode
(2) When
selecting
operation
Text used for each operation When you bring the cursor to a character and press [ENTER]
key, the character is entered. After you nish entering
characters, move the cursor to OK and then press [ENTER]
key.
<Setting example>
Example of operation procedure to enter the “TEST01” to create the new le name is described.
(1) Character input eld (using the [ENTER] key)
(2) Select character type, delete, insert, conrm
(3) Character selection
<Keys to be used >
• (1) Set the operation mode to “A” (Uppercase alphabet mode).
• (2) Select the [TEST] in the Character input.
• (1) Set the operation mode to “0” (Numeric mode).
• (2) Select the “01” in the character input.
If you make a mistake to enter the character, move the cursor on the character you want to delete with
Fast forward key and (1) place in the position of the
in the operation mode and then press the
[ENTER] key to delete the one character.
• After completing character input, confirm by setting operation selection to [OK] and then pressing the
[ENTER] key.
* When setting the display language to language other than Japanese, Half-width Kana mode cannot be
used in "(1) Operation selection".
To Next Page
Loading...
