GRAPHTEC midi LOGGER GL240 - LAN Setting

3-56
CHAPTER 3 Settings and Measurement
(5) LAN setting
Perform the I/F wireless LAN unit setting and the wireless sensor registration.
* When optional wireless LAN is not installed in the GL240, this screen is not displayed.
<Station settings> <Access point settings>
Setting Selections available
Wireless LAN Off, station, access point
Station setting SSID input Character string input
SSID search Press right key to execute
Automatic
setting (WPS)
WPS system Push button method / PIN method
WPS execute Press right key to execute
Encryption method None, WEP, WPA-PSK/WPA2-PSK
11n Off, On
Reection of setting Press right key to execute
Other setting
(When the station
is set)
Connect / disconnect Press right key to execute
ST-IP setting IP address automatic acquisition Not used or used
IP address 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
Subnet mask 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
Port number 1024 to 65535
Gateway 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
DNS address 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
Server setting Perform each server setting.
For details, refer to “(5)-6 Server setting”.
Reection of setting Press right key to execute
Access point
setting
SSID input Character string input
Automatic
setting (WPS)
WPS system Push button method / PIN method
WPS execute Press right key to execute
Encryption method None, WEP, WPA-PSK/WPA2-PSK
Channel 1ch to 13ch
Stealth Off, On
11n Off, On
Reection of setting Press right key to execute
Reection of
setting
(When the Access
point is set)
AP-IP setting IP address 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
Subnet mask 0 to 255.0 to 255.0 to 255.0 to 255
(only when the IP address automatic acquisition is not used.)
Port number 1024 to 65535
Server setting Perform each server setting.
For details, refer to “(5)-6 Server setting”.
Reection of setting Press right key to execute
Wireless
sensor setting
Connection Off, On
Module name Character string input
Search Press right key to execute
AMP1 Display the set sensor.
AMP2 Display the set sensor.