GRAPHTEC midi LOGGER GL240 - 3.1 Window Names and Functions

3-2
CHAPTER 3 Settings and Measurement
3.1 Window names and functions
1. Simplied message display
2. Time/DIV display area
3. Status mark
4. Wireless sensor display
5. Device access display
(Internal memory)
6. Device access display
(SD memory card 2 / wireless LAN display)
7. Remote lamp
8. Key lock display
9. Clock display
10. AC/Battery status indicator
11. Digital display area
12. Quick settings
13. Alarm display area
14. Pen display
16. File name display area
17. Scale lower limit
18. Waveform display area
19. Scale upper limit
20. Data capture bar
15. Time stamp
1. Simplied message display
Displays the operation status of the GL240.
: Appears in the start up status or when data is not being captured.
: Appears while waiting for trigger generation after measurement is started.
* : Displayed when the data is captured to the internal memory (SD1).
* : Displayed when the data is captured to the SD memory card (SD2).
* : Displayed when performing the capturing stop process.
: Appears when the GL240 waits for you to press the [START/STOP] key to stop it
after data capture.
* : Displayed when the data in the internal memory (SD1) is replayed.
* : Displayed when the data in the SD memory card (SD2) is replayed.
: Appears when backup fails (e.g. when the SD memory card specied as the backup
destination has been removed).
: Appears when a demo waveform is being displayed, not measurement data.
* Refer to "(3) TRIG settings" in "3.4 Setting Menus" for details on the data capture such as a trigger and repeat.
* Refer to “(2)-2 Captured data le name” in “3.4 Setting Nemus” for details on data capture setting.
Please do not turn off the power when the “ * “ status icon is displayed or the device is being accessed.
The data that has been captured or is being captured is may be damaged.
Please start the operation after making sure that the status mark is switched to "STOP".
The internal memory is displayed as the SD1 or SD CARD1.