GRAPHTEC midi LOGGER GL240 - TRIG Settings

3-49
CHAPTER 3 Settings and Measurement
(3) TRIG settings
This is used to specify trigger conditions and alarms.
* When the GL100-WL+GS sensor is connected, the level alarm can be set as well.
Setting Selections available
Start Side Source Setting Off, Level, Alarm, External Input, Date, Weekly, Time
[Level] Mode Analog: Off, H, L, Window In, Window Out
Logic: Off, H, L
Pulse: Off, H, L, Window In, Window Out
Combination Level OR, Level AND, Edge OR, Edge AND
Level Set numeric value
[Alarm] Alarm port
number
1, 2, 3, 4, WL1
[Date] Date From 2005.1.1 to 2035.12.31
Time From 0:0:0 to 23:59:59
[Weekly] Day of week Off or On setting for each of Sunday through Saturday
Time From 0:0:0 to 23:59:59
[Time] From 0:0:1 to 9999:59:59
Stop Side Source Setting Off, Level, Alarm, External Input, Date, Weekly, Time
[Level] Mode Analog: Off, H, L, Window In, Window Out
Logic: Off, H, L
Pulse: Off, H, L, Window In, Window Out
Combination Level OR, Level AND, Edge OR, Edge AND
Level Set numeric value
[Alarm Alarm port
number
1, 2, 3, 4, WL1
[Date] Date From 2005.1.1 to 2035.12.31
Time From 0:0:0 to 23:59:59
[Weekly] Day of week Off or On setting for each of Sunday through Saturday
Time From 0:0:0 to 23:59:59
[Time] From 0:0:1 to 9999:59:59
Repeated Capturing Off, On
Alarm Level
Settings
Mode Analog: Off, H, L, Window In, Window Out
Logic: Off, H, L
Pulse: Off, H, L, Window In, Window Out
Level Set numeric value
Output 1, 2, 3, 4, WL1
Detection Method Level, Edge
Alarm Hold Held or Not held
Send Burnout Alarm Sent or not sent