2-10
CHAPTER 2 Checks and Preparation
2.7 Mounting the SD Memory Card
•
When the SD memory card is inserted, make sure that the card is not locked. If locked, the data cannot be
captured.
•
Please do not remove the SD memory card while accessing to the SD memory card (Device Access display
is displayed in "red" and POWER LED is blinking.). The captured data may be damaged.
•
When inserting the large capacity SD memory card, it may take some time to recognize it.
How to insert the SD memory card (SD CARD2)
Insert the SD memory card into the SD CARD2 slot.
When the optional wireless LAN unit is installed, the SD memory card cannot be inserted.
(1) Remove the SD CARD2 protective cover.
Protective cover
(2) Insert the SD memory card until it clicks and is locked.
* Make sure that the SD memory card is not locked.
SD CARD
x GB
Lock
* Make sure that the SD memory card
is not locked.
SD memory card
(3) Insert and close the protective cover into the upper hole and lower hole for the SD CARD2 protective
cover.
Protective cover
To Next Page
Loading...
