3-41
CHAPTER 3 Settings and Measurement
(1)-43 Range setting
Select the range of the current (power) to measure.
Setting Description
Current 50, 100, 200A
Power (20, 50, 100kW) It is linked to the current range.
Do not change the range through the GL100-WL after setting the range of the GL240.
The displayed values of the GL240 may not match the measured values.
(1)-44 EU setting
This is used to unit-convert the measurement signal.
Refer to “<Setting example: For voltage input>” in “(1)-5 EU (Scaling settings)” in “3.4 Setting Menus”.
Even if the scaling setting is applied to the original measured value of CH, the accumulated power is not
reected in the accumulated power CH.
(1)-45 Other setting
The following settings can be performed.
Setting Description
Annotation text string Set the annotation (comment) displayed in the CH.
Program Inter-CH
calculation
Set the contents of Program Inter-CH calculation.
Four arithmetic operations (addition (+), subtraction (-), multiplication (x), division (÷)) can be used for
the Program Inter-CH calculation.
* For detaols, refer to “<Inter-CH Op Settings>” in “(1)-6 Misc.” in “3.4 Setting Menus”.
Span setting Set the upper and lower limits of the span which the waveform is displayed.
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Line Thickness Setting 1 to 8 dots
Trace This is used to set the waveform display.
Voltage value
(Power only)
Set the measurement voltage value to calculate the power within the range of 90 to 264V.
Power factor (Power only) Set the power factor to calculate the power within the range of 0.30 to1.00.
Auto zero adjustment The current input current value is calculated as a zero point current value.
Zero adjustment reset Reset the zero point current value.
* This function is not applied to power measurement.
Zero point voltage value Display the zero point current value.
* This function is not applied to power measurement.
To Next Page
Loading...
