EasyManuals Logo

Grasshopper 721DT User Manual

Grasshopper 721DT
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
OPERATION
The safe operation of this machine is the
responsibility of the operator. The operator
should be familiar with the tractor and all at-
tachments that will be used before starting
operation. Refer to and read safety informa-
tion on pages 6 through 11.
CONTROLS AND SWITCHES
Know your controls and how to stop tractor,
engine and attachments quickly in an emer-
gency.
Stop tractor by moving steering levers
to neutral position (refer to section on
steering lever operation, page 19-20).
Stop engine by turning key to “OFF”
position.
Disengage power to attachments by
moving PTO switch to “OFF” (down)
position.
Operating this unit is not difficult once you
master the use of the controls. We recommend
you equip the tractor with the attachment you
will be using and practice in a at open area
at a medium throttle setting until you are com-
fortable with the controls.
Before operating this machine be
sure the operator-presence safety
system works. The engine should
not run without the operator in the
seat if the PTO switch is on or either
steering lever is in the run position.
Several safety switches are incorporated in
the unit’s design to prevent it from being start-
ed out of neutral or with the PTO engaged. All
controls must be in the “OFF” or neutral posi-
tion before the unit can be started. There is a
safety switch under the operator’s seat that
will cause the engine to stop should the oper-
ator leave the seat with any control engaged.
PRESTART CHECK LIST
Place tractor on level surface.
Check crankcase oil level (refer to “Engine
Manual” for proper level and type of oil
used).
Never attempt to check oil while en-
gine is running.
Check radiator coolant.
Do not remove radiator cap while
engine is hot!
Remove and clean air intake screen on
radiator.
When mowing in dusty conditions,
dry grass or long grass, it may be
necessary to remove and clean air
intake on the radiator frequently to
prevent engine overheating.
Check for grass wrapped around PTO
shaft. When mowing long grass, turn off
key and check for grass wrapped around
PTO shaft every 30 minutes of operation.
Remove fuel solenoid wire to pre-
vent accidental engine starting
before attempting to remove grass
from around PTO shaft.
Check air cleaner (refer to “Engine Manu-
al”). When mowing in dusty conditions, dry
grass or long grass, it may be necessary
to remove and clean air intake on the air
cleaner.
Check to be sure engine is free of dirt and
debris.
Check fuel level. Refer to “Engine Manual”
for correct fuel for your requirements.
IMPORTANT
CAUTION
CAUTION
WARNING
WARNING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grasshopper 721DT and is the answer not in the manual?

Grasshopper 721DT Specifications

General IconGeneral
BrandGrasshopper
Model721DT
CategoryLawn Mower
LanguageEnglish

Related product manuals