17 / 24
S1032_mz-8P_V1.1sh
Forward and backward (nick)
Change control mode
The transmitter mz-8P HoTT is delivered as standard only in Mode 2,
with throttle / pitch and yaw on the left. This configuration can be
changed via firmware update to Mode 4, with throttle / pitch and
yaw on the left.
The required software "S1032_MZ-8P_M34_xxx.bin" can be down-
loaded free of charge from the mz-8P HoTT product page at
www.graupner.de.
MODE 2 (Throle/Pitch le)
Motor / Pitch
Motor / Pitch
Yaw
Yaw
Nick
Nick
Roll
Motor / Pitch
Motor / Pitch
Roll
Roll
Nick
Nick
Yaw
Yaw
MODE 4 (Throle/Pitch le)
Note
After switching to mode 4, the control function "yaw" is on the right
and the roll function on the left control stick.
Fail-Safe function
If the radio connection is interrupted for less than approx. 0.5 sec-
onds, the factory setting is to "hold" the control signals last recog-
nized as correct. If the disturb lasts longer, the motors will be
switched "OFF" after expiry of this period.
To Next Page
Loading...
Need help?
General
