19 / 24
S1032_mz-8P_V1.1sh
SPEED button
In the "Motor OFF" mode of the transmitter, each press of this but-
ton will rotate in rotation to the next of three preset path settings:
• 3-times signal
Pitch -94 … +100 %
Roll/Nick/Yaw ±100 %
(Standard setting after binding a receiver)
• 2-times signal
Pitch: -94 … +55 %
Roll/Nick/Yaw ±60 %
• 1-times signal
Pitch: -94 … +55 %
Roll/Nick/Yaw ±40 %
SNAP button
1. Each short press triggers a snapshot. For confirmation, the red
CAMERA LED lights up for approx. 1 second each.
2. Each long press switches channel 8 between + and -100%. Only
usable with compatible copters.
RECORD button
Pressing this button starts the video recording on a compatible cop-
ter. As confirmation, a low beep sounds and the CAMERA LED starts
to light rhythmically. Another pressure stops the recording. The red
flashing CAMERA LED goes out and a bright 2x signal sounds.
Auto-Flip function
If the copter is in attitude mode, a compatible copter can inde-
pendently flip or roll over in any direction.
Trigger a rollover step-by-step
1. Press the completely self-neutralizing control stick.
For about 5 seconds, a fast beep will sound.
2. As long as the beep is heard, move the roll or pitch stick more
than 50% of its way toward the end stop while simultaneously
"accelerating" so that the copter does not lose altitude during the
flip.
The copter makes a self-rollover in the direction in which it is
headed.
To Next Page
Loading...
Need help?
General
