25 / 40
33028_mc28_T1V3_sh_en
Adjust control mode
Mod.name
Stick mode
1
BASIC SETTINGS, MODEL
SEL
n/a
bind
Rcv Ch Map R12
n/a
module
HoTT
By default, the transmitter is supplied with the software control
mode 1. Accordingly, each newly created model memory is initial-
ized with the control mode 1.
However, this default value can be adapted to your own habits at any
time in the “Stick mode” line of the “Basic setup model” menu.
Change stick mode step-by-step
1. Change to the »Basic setup model« menu.
2. Move into the line “Stick mode”.
3. Press the ENT key.
4. Select the desired control mode with the selection buttons
5. Press the ENT key.
6. Exit the menu by pressing the ESC key.
The following control modes are available
(Airplanes)
MODE 2 (Throttle left)
Elevator
Elevator
Rudder
Rudder
Full throttle
Motor idle
Querruder
Querruder
Full throttle
Motor idle
Rudder
Rudder
Elevator
Elevator
Aileron
Aileron
Elevator
Elevator
Aileron
Aileron
Full throttle
Motor idle
Rudder
Rudder
Full throttle
Motor idle
Aileron
Aileron
Elevator
Elevator
Rudder
Rudder
MODE 1 (Throttle right)
MODE 3 (Throttle right)
MODE 4 (Throttle left)
(Helicopter)
MODE 2 (Throttle left)
Nick
Nick
Tail rotor
Tail rotor
Motor / Pitch
Motor / Pitch
Roll
Roll
Motor / Pitch
Motor / Pitch
Tail rotor
Tail rotor
Nick
Nick
Roll
Roll
Nick
Nick
Roll
Roll
Motor / Pitch
Motor / Pitch
Tail rotor
Tail rotor
Motor / Pitch
Motor / Pitch
Roll
Roll
Nick
Nick
Tail rotor
Tail rotor
MODE 1 (Throttle right)
MODE 3 (Throttle right)
MODE 4 (Throttle left)
To Next Page
Loading...
