Touch Touch
Touch Touch
TouchTouch
Touch
Touch
Check Check
Touch
Touch
SEL
IMP.M
EXP.M
Touch
1-3. IMP.M (IMP. Model)
It is used to copy the model memory in SD Card into the model list of transmitter. To make use of
IMP.M function, you need SD Card that has the programmed model le. If you put SD Card into SD
Card slot on the back of transmitter, “SD Card” icon is lighted in the transmitter main page. When
the icon is lighted, touch the base setup icon to call the base setup page. In the page, touch “Mod-
el Select” icon to call the “Model Sel” setup page and touch the copy destination then it is activated
in blue. Touch “IMP.M” icon then the model list in SD Card appears and then select the source
model to copy. The popup message indicating the destination and source appears. Touch YES, if
they are correct, then “Please wait” message is displayed and a few seconds later, the model data
in SD Card is copied to the model list in transmitter.
11
To Next Page
Loading...
Need help?
General
