- DSC OUTPUT
It is used to set the number of channel when Trainer function is used with DSC jack. If 5 channels
are used, PPM5 is recommended to use. To use more than 5 channels, choose the appropriate
PPM for each condition. PPM10, PPM16, PPM18, PPM24 are selectable.
Whenever you touch the value icon in DSC OUTPUT, You can select “PPM10”, “PPM16”,
“PPM18”, and “PPM 24” in turn. Default value is “PPM 10”.
8. TIMER
Timer function may be set for any desired time ,i.e. model time, date, time, etc. Two independ-
ent timers, TIMER1 and TIMER2, are provided for each model. Touch “Timer” icon in base
menu page to call the timer setup page.
Timer consists of TIMER1 and TIMER2. The ight data is saved to SD card on transmitter
during the ight time is operating in TIMER1 mode but TIMER2 don’t have the storing function
for the ight data.
The timer in the rst page is the ight time setup line. Touch the value in minute or second to
operate and stop timer and touch “T.RES” icon to reset the ight time
Touch
Touch
Touch
Touch
Touch Touch
Touch
20
To Next Page
Loading...
Need help?
General
