Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
“Wizard setup” is used to set the basic function of a model and the essential function of ight one
by one. Please refer to the example of helicopter type as below.
Touch the icon of desired model you want to program Wizard setup in the model list and touch
“NEW” icon then the “Select” message is popped up. If you touch “WIZ” icon, WIZARD function
is ready to set. The rst function of wizard setting is MODEL NAME. Tap model name in blank of
New Model Name using keypad on the right. Touch EN icon on the right bottom and touch WIZ
icon on the left top then the model is named and stored and then the next function, model type, is
accessed.
• Alphabet keyboard explanation.
- CL(Clear):it is used to erase every letter you typed at a time.
- SP(SPACE):it is used to make a space between words
- DE(DELETE):it is used to erase a letter you typed
- EN(ENTER):it is used to save every letter you typed.
- CAPS:it is used for capital letters or small letters
- NUM:it is used for numbers.
- SPECIAL:it is used for special character.
In accordance with model type that you selected, swash type function or wing type function is
accessed. Below picture shows the example for swash type in helicopter. Select the desired swash
type, power type and set reverse function, EPA function, D/R EXP function, Pit CRV function, Thr.
CRV function, GYRO function, Thr.HOLD function, FAILSAFE function in turn. When you touch
WIZ icon after completing to program each function, the next step is accessed in turn. When you
touch WIZ after FAILSAFE function is programmed nally, “Model type”, “Swash type”, and “Power
type” that you selected appear on the page. Touch ENT icon on the right bottom after checking the
selected types, Wizard setup is completed and returned to base menu
Touch
9
To Next Page
Loading...
Need help?
General
