GRAUPNER mz-18 HoTT User Manual

1-5. RES(RESET)
It allows you to remove the selected models in model list. Refer to the example of Model 01
as shown below. At rst, you need to select the desired model that you want to remove then
the model icon is activated in blue. “Please wait” message is popped up when you touch
“YES” icon. All the data of the corresponding model is removed within a few second.
YES
INITIALIZE
SURE
NO
YES
MODEL
CHANGE
NO
1-6. CPY(Model Copy)
The Copy function is used to copy the programmed values of a model into the other model.
Touch the source model to copy, it is activated in blue. Now touch “CPY” icon on the right
bottom and touch the copy destination then it is activated in blue as well. The popup message
indicating the destination and source appear. Touch YES, if they are correct, then “Please
wait” message is displayed and a few seconds later, the source data is copied to the copy
destination.
SEL
SEL
SEL
SEL
SEL
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
Touch
Touch
Touch
SEL
SEL
SEL
SEL
SEL
SEL
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
IMP.M
EXP.M
Touch
Touch
Touch
Touch
13

GRAUPNER mz-18 HoTT Specifications

General

Brand	GRAUPNER
Model	mz-18 HoTT
Category	Remote Control
Language	English