Touch
Touch
Touch
Touch
Touch Touch
Touch
Touch
4. Reverse
It is used to reverse the operation of an individual servo. Touch the “Reverse” icon in the base
menu page to call the Reverse setup page. In “Reverse” page, you are able to reverse the oper-
ation of a servo. When you touch the “NOR” icon, “NOR” is changed to REV” and the operation
of an individual servo is reversed. Touch “Servo” icon on the left top to call the “Servo View” page
after setting “Reverse” function. When each channel’s stick is controlled, “Reverse” setting status
can be seen in a graph. Now, touch “Back” icon in the servo view page to call the reverse setup
page. When Reverse function setting is completed, touch “Back” icon on the top left page to call
the Base menu page.
Touch
Touch
Touch
Touch
15
To Next Page
Loading...
Need help?
General
