Touch
Touch
7. BINDING
You must bind the receiver to the transmitter before the receiver will operate. Binding
teaches the receiver the specic code of the transmitter so that it will only connect to it’s
corresponding transmitter. If you turn on transmitter’s power before binding, the warning
message appears on transmitter LCD page, which announce transmitter is not bound.
Touch SET icon on warning pop up to access to Tx ctl (BIND)
After accessing to Tx ctl(BIND), Turn on receiver’s power and press & hold Bind button
on receiver for over 3 sec to enter binding mode. Touch OFF icon to switch to ON, which
is in the cross line of BIND ON/OFF and RX1 then the system has been connected. If the
binding process has failed, repeat the whole procedure.
CAUTION
We strongly recommend that you wouldn’t use throttle limit function in Helicopter type since
throttle limit function restricts the travel amount of throttle with DV1 volume.
In order to cancel throttle limit function, touch “BASE” icon at the main page to call “BASE”
page and touch “CH set” icon to call “CH set” setup page. Touch DV1 in channel 9 then
“Select” message popup appears. Now, touch CLR in popup. DV1 is switched to NONE
indicating throttle limit function is canceled
Throttle limit function should be canceled depending on the situation
Gyro
Governor
Aux 2
Aux 3
Aux 4
Aux 5
Pitch
Roll 1
Pitch-axis 1
Tail rotor
Aux 1
Throttle
HELI 1
Touch Touch
Pitch
Roll 1
Pitch-axis 1
Tail rotor
Aux 1
Throttle
Gyro
Governor
Aux 2
Aux 3
Aux 4
Aux 5
HELI 1
Pitch
Roll 1
Pitch-axis 1
Tail rotor
Aux 1
Throttle
Gyro
Governor
Aux 2
Aux 3
Aux 4
Aux 5
HELI 1
Touch
5
To Next Page
Loading...
Need help?
General
