Gravely Pro-Turn 200 - Adjust Deck Lift Pedal; Remove; Install Mower Deck

EN - 38
ADJUST DECK LIFT PEDAL
See Figure 55.
1. Remove hardware securing deck lift
pedal to deck lift arm.
2. Place pedal in desired position.
3. Reinstall hardware and torque to 71 – 95
N•m (52 – 70 lb-ft).
REMOVE / INSTALL MOWER
DECK
Remove Deck
1. Remove PTO belt from clutch. See
Remove PTO Belt on page 34.
2. Push deck lift pedal completely forward to
engage transport lock.
3. Position supports such as blocks or jack
stands under each side of the deck.
4. Release transport lock and slowly lower
deck until it rests on supports.
5. Slowly disconnect lift-assist springs from
spring peg on each side of deck. See
Figure 56.
See Figure 57.
6. Remove hardware retaining deck lift links
to deck lift brackets.
7. Remove rear mounting pins securing
mounting arms to deck.
Figure 54
Figure 55
1. Deck Lift Arm
2. Deck Lift Pedal
1
2
WARNING: AVOID INJURY.
Springs store energy. Keep body
parts away from pinch points
when removing the deck.
WARNING: AVOID INJURY.
Mower lift arms and lift pedal
could cause severe injury if the
lift-assist springs are not
disconnected before the lift links.
Figure 56
1. Lift-Assist Spring
2. Spring Peg
1
2