IS200 TX machine . 6
First contact
Stages of unpacking
Before opening the cardboard box, check that it is the right way up.
1. Cut the straps (photo 1).
2. Lift the box off vertically.
3. Take out the cardboard stand (photo 2).
4. Take out the tool box (photo 3).
5. Loosen the two screws with a 13 key.
6. Take off the two protective bars with the
stands (marked G (L) and D (R) for left
and right sides).
7. Loosen the screws with a 13 key and take
out the slats (photo 4).
8. Take out the protective housing .
9. Take the machine out (get someone to help
you).
Always move the machine with 2 people.
Make sure that no components are missing from the package. If any part has
been forgotten please get in touch with your GRAVOGRAPH dealer.
Keep all the packaging materials so that you can move your IS200 TX machine in total safety.
This packaging is in conformity with European recycling standards.
To Next Page
