Great Computer JII-61 - Descriptions of Features; Setting Up Menu - On-line Mode

Jaguar II User Manual
3. Descriptions of Features
This chapter describes the button operation with the LCM menu flowcharts of Jaguar II. When
the cutting plotter is ready for use as described in Chapter 1 & 2, all functions are under default
parameters.
3.1 Setting up Menu—Jaguar II in on line mode
Power On
Firm w a re V-.--
Copyright 2002
In itia liz in g ---c m
Cutter please wait
Media check
Place Media and Lower
down the lever
Roll Edge Single
K ey K ey K ey
Sizing M edia W idth
Lever Up to Abort
Siziing Media Length
Lever Up to Abort
S ---.- F ---.- O -.-- M
L:-----.-- W : ----.--
Top m enu
Data In Processing
Sending data
Pause
Setup Resum e
[PAUSE]
Force: 80 gf
O K : E N TE R
[F orc e k ey]
Jaguar II in processing
U se to s e lect
U se to se lect; [E N TE R ]to e n ab le the se tting
O ffs et: 0 .27 5 m m
O K : E N TE R
Clear data m em ory
N: Cancel O K: ENTER
1S:72 F:80 O : 0.275 M
S elec t O K : E N TE R
[O ffs et k ey]
[Data Clear]
[Tool Select]
Speed: 72cm /s
S elec t: O K : E N TE R
[Speed Key]
Up Speed: 72cm /s
S elec t: O K : E N TE R
Q uality: N o rm al
S elec t: O K : E N TE R
Set Sm oothing Cut
S elec t: O K : E n ter
Set Tangetial Mode
S elec t: O K : E n ter
P ounc ing 0.00 m m
S elec t: O K : E n ter
Panel Setup
S elec t: O K : E n ter
O verC u t: 0.0 0m m
S elec t: O K : E n ter
Restore default ?
S elec t: O K : E n ter
Save param eter ?
S elec t: O K : E n ter
Description of Operation 3-1