Great Computer JII-61 - Setting Up Menu - Off-line Mode

Jaguar II User Manual
3.2 Setting up Menu—Jaguar II in off line mode
Press[ON/OFF LINE] switch to offline mode
Offline For
System Setup
[Force Key]
[OFFSET KEY]
[Data Clear ]
[ ]
[Speed Key]
[Cut Test]
[Tool Select]
[Misc]
Force: 80 gf
? OK: Enter
Offset 0.275 mm
OK: Enter
Clear Data Memery
N: Cancel OK: Enter
Move Origin
X: Y:
Speed: 72cm/s
Select: OK: Enter
Up Speed: 72cm /s
Select: OK: Enter
Quality: Normal
Select: OK: Enter
Square Cut
Select: OK: Enter
Repeat Last Plot
Select: OK: Enter
Mark positions
Select: OK:Enter
Auto Unrolled Media
Select: OK:Enter
Media Back & Forth
Select: OK: Enter
Paper Saving Mode
Select: OK:Enter
Set Communication
Select: OK: Enter
Select Language
Select: OK: Enter
Select Units
Select: OK: Enter
Scale Length
Select: OK:Enter
Scale Width
Select: OK: Enter
1S: 72 F:80 O: 0.275 M
Select OK: Enter
Set Smoothing Cut
Select: OK: Enter
Set Tangetial Mode
Select: OK: Enter
Pouncing 0.00mm
Select: OK: Enter
Panel Setup
Select: OK: Enter
Speed: 3-153cm/s with an increment of 3cm/s
Upspeed: 3-153cm/s with an increment of 3cm/s
Draft, Fair, Normal, Fine, Small Letter
0-600gram with an increment of 5 gf
0.000-1.000mm with an increment of 0.025mm
English, Spanish, Italian, Deutsch, Japanese,
Portuguese, Polish, Turkish, French
Metric (cm/ gf) or English
measurement(feet/ounce)
Firmware: x.x.xx
FPGA: Vx.x mm/dd/yy
OverCut: 0.00mm
Select: OK: Enter
Restore default ?
Select: OK: Enter
Save parameter ?
Select: OK: Enter
OverCut: 0.00-1.00 mm with an increment of
0.05 mm
Pouncing: 0-200 mm with an increment of
1 mm
Both Expanded Mode, Length Expanded Mode,
Width Expanded Mode, Both Unexpanded Mode
Description of Operation 3-2