Great Computer JII-61 - Software Problems

Jaguar II User Manual
Troubleshooting 6-4
6.4 Software Problems
Check the following first:
Does your software package indicate that it will work with you
r
computer and cutting plotter?
Does your software support HP-GL and HP-GL/2 drivers?
(* check the configuration settings of your software.)
Yes
No
Does the cutting plotter interface
match the requirements of your
software?
Does your
software
recommend using
a different cable?
Does the software
vendor provide a
sample file?
Most well known cutting softwares in
the world have drivers for our cutting
p
lotters. If not, use software that has
HP-GL and HP-GL/2 emulatio
n
supports and you can chose the
following three drivers:
#
A3 size: HP7475A
#
A1 size: HP7580A
#
A0 size: HP Draf Pro Exl or HP
Draf Master
Yes
No
Refer to Chapter 4,
connecting your
cutting plotter.
Yes
No
Try using the
recommended
cable.
Yes No
Re-power on the
cutting plotter and
try to send the file
again.
Do something about the
error message display on
LCM, or consult your
software vendor.