Great Computer JII-61 - Media Loading; Loading the Sheet Media

Jaguar II User Manual
Installation and Operation of Sign Cutting Plotter 2-9
Figure 2-19
2.4 Media Loading
2.5.1 Loading the Sheet Media
To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or
lower down pinch rollers. Pull the lever forward until it makes a clicking
sound then the pinch rollers are raised (Figure 2-17).
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or
the backside. The color alignment rulers on the platen extension will help you to adjust the
media precisely.
Step 3
Then move the pinch rollers manually to the proper
position. Be sure the pinch rollers must be positioned
above the grid drum. The white marks on the main
beam will remind you where the grid drums are
(Figure 2-19).
Step 4
Push the lever backward to lower down the pinch rollers.
Fi
g
ure 2-17
Lever
Note: Be sure that the media
must cover the paper sensors on
the platen when loading the
media. At least one of the two
paper sensors (Figure2-18)
should be covered. Once the
media covers the sensor, the
cutting plotter will size the
media’s width and length
automatically.
Paper
Figure 2-18
White