Fig.5.2 Page of Single IDU Control
(1) General Control Parameters
1) On/off
Press the on/off button to turn unit on or off.
When unit is turned off, mode, temperature,fan speed and swing can’t be set.
2) Mode setting
Press the Mode buttons to set unit’s operation mode.
Modes for indoor units of different series are not all the same.
If a certain mode is not available in the indoor unit, the icon of the
corresponding mode cannot be selected.
Note:
① Only master indoor unit can set auto mode; absence mode can be set only
when one indoor unit is turned on and this indoor unit shall be the bedroom
indoor unit with three refrigerant pipes.
② Heat recollection system have no master indoor unit. When the indoor unit
of the same branch is connected into one indoor unit, the auto mode can
be set; when the quantity of indoor unit in the same branch is more than
one set, the auto mode cannot be set; other modes can be freely switched.
3) Temperature setting
Press the up or down buttons to adjust temperature. Each time pressing the
button will increase/decrease the temperature by 1. Holding down the button can
increase/decrease temperature continuously.
To Next Page
Loading...
