Multi-VRF Centralized Controller
16
Pressing the button can display the “indoor temp” and “outdoor temp”.
Note:For Bedroom IDU, Press the up or down buttons to adjust temperature.
Each time pressing the button will increase/decrease the temperature by 0.5.
4) Humidity setting
Press temperature and humidity switching button to switch to the humidity
setting interface. Press the up or down button to adjust humidity. Each time
pressing the button will increase/decrease the humidity by 5%. Holding down the
button can increase/decrease humidity continuously within the range from 45% to
65%.
Note: Humidity Setting function is particular for Bedroom air condition. other air
condition without Humidity Setting function.
5) Fan speed setting
Press or drag the fan speed bar to set unit’s fan speed.
Note: Unit defaults to low fan speed in dry mode. Fan speed cannot be set in
drying or floor heating mode.
Auto fan speed is defaulted in absence mode and fan speed cannot be set; low
fan speed is defaulted in auto dry mode and cannot be set; high fan speed is
defaulted in clothes drying mode and cannot be set.
6) Swing setting
Pressing the button “Up-Down Swing” or “Left-Right Swing” can turn on or off
the swing function.
Note: Swing types for indoor units of different series are not all the same.
7) Malfunction View
When indoor unit fails to function well, press the button to view the
information of malfunctions.
(2) Advanced Control Parameters
Press Advance Button to enter the advance page.
Press icon buttons to turn on or off the corresponding function.
To Next Page
Loading...
