Multi-VRF Centralized Controller
30
1) When switching between indoor network and outdoor network, or reset
unit IP, restore the ex-factory setting for centralized controller.
2) After debugging for the centralized controller is finished, connect in to the
network. If connect the centralized controller to the network during
debugging process, it needs to restore the defaulted ex-factory setting.
(9) View Selecting
Press“View Selecting”,Choose Room View or Device View.
5.9 Engineering Setting
On the home page, press setting to enter into setting interface.
Press the “Project Setting” button to switch to engineering setting, the operation
method is the same as the setting of this unit.
(1) Indoor unit register
Enter into the indoor unit register interface, select the chosen indoor unit
according to the displayed engineering No. of indoor unit icon, and then press
to save, it will display the registered indoor unit in the home page.
Notes: There are 32 sets of indoor units can be registered at most.
(2) Name&Icon setting
Switch to name&Icon setting interface to select the engineering No., and set
the name and icon of indoor unit.
Fig. 5.12 Setting Page of Indoor Unit
Press the Engineering No. to select the required indoor unit that needs to be
To Next Page
Loading...
