valid after the detection. That is, when the status of fresh air unit is changed
by other ways, it will not be controlled by the energy-saving strategy any
more.
② The fresh air unit which is not connected with air box or the fresh air unit with
auto mode invalid are not controlled by smart switch and energy-saving
strategy.
6.2.3 Room Parameter Setting
Click
“
Parameter setting
”
button to enter the setting interface of room
parameter.
Fig. 6.3 Diagram of Room Parameter Setting
1) Time setting
Click
“
Unit on time
”
or
“
Unit off time
”
button to enter time setting page.
You can set timer to turn on or turn off the smart switch in this room. Click
in front of the button to turn on unit on time or unit off time.
Note: Unit on time and unit off time can be set simultaneously. But the set time
shall be different.
2) Schedule repeat
Click
“
Repeat setting
”
button to enter setting page. You can set the schedule
repeat time according to week.
3) Temperature setting
Click
“
Temperature setting
”
button to enter temperature setting page. You
To Next Page
Loading...
