Multi-VRF Centralized Controller
36
can set target temperature of the room.
4) Humidity setting
Click
“
Humidity setting
”
button to enter humidity setting page. You can set
target humidity of the room.
Note: Humidity setting is only available for the indoor unit with humidity
adjustment function.
5) Fan speed setting
Click
“
Fan speed setting
”
button to enter fan speed setting page. You can
set target fan speed of indoor unit and fresh air unit in this room.
6) Save setting
If smart switch is turned on, click button to send set target temperature,
target humidity and target fan speed immediately; mode command will be sent
intelligently according to indoor temperature, outdoor temperature and target
temperature. If smart switch is turned off, click button to save relevant
setting parameters.
6.2.4 Room Device List
Fig. 6.4 Page of Room Device List
Click
“
Device list
”
button to enter device list interface of the room.
In device list interface, click indoor unit icon to enter single unit control.
Press indoor unit icon for 5 seconds to pop up indoor unit name, project
To Next Page
Loading...
