EasyManua.ls Logo

Gree DC Inverter Multi VRF

Gree DC Inverter Multi VRF
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DC INVERTER MULTI VRF INSTALLATION
128
6. Make sure that there are enough space for care and maintenance. Make sure that the weight between the
indoor unit and ground is above 1800mm.
7. When installing the steeve bolt, check if the install place can stand the weight 4 times of the unit’s. If not,
reinforce before installation. (Refer to the install cardboard and find where should be reinforced)
Note
There will be lots of lampblack and dust stick on the acentric, heat exchanger and water pump in dining
room and kitchen, which would reduce the capacity of heat exchanger, lead water leakage and abnormal
operation of the water pump. The following treatment should be taken under this circumstance:
1. Ensure that the smoke trap above cooker has enough capacity to obviate lampblack to prevent the indraft
of the lampblack by the air conditioner.
2. Keep the air conditioner far from the kitchen so that the lampblack would not be indraft by the air
conditioner.
Important notice:
To guarantee the good performance, the unit must be installed by professional personnel according with
this instruction.
Please contact the local Gree special nominated repair department before installation. Any malfunction
caused by the unit that is installed by the department that is not special nominated by Gree would not deal
with on time by the inconvenience of the business contact.
Dimension of ceiling opening and location of the hoisting screw (M10)

Table of Contents

Related product manuals