DC INVERTER MULTI VRF CONTROL
79
Note: The above figure is only for reference to relation among the equipments. The actual wiring is subject to the
above frame diagram of system
●Step 3: There are two methods of DIP address setting of communication module
Method 1: The address of each communication module has been fixed in the factory and marked on the label at the
back of it. It is unnecessary for users to set anything. In addition, the 3-digital DIP can not be dialed to OFF completely, as
shown below:
Method 2: Manual setting of address, as operated the following:
1. Dial the digital switch at the back of communication module to OFF completely, as below:
Label for address of
communication module
To Next Page
Loading...
