Unit Control
55
[Notes]
① Once it is activated, it should be deactivated manually.
② This setting will be memorized upon power failure.
③ The saved “Start time” and “End time” will be memorized upon power failure.
④ It is configurable no matter whether the unit is in operation or not.
3.2.2.9 Weather-dependent Mode
For areas with large change of diurnal temperature, in order to avoid the user to set the leaving
water temperature or room temperature too often, this function will adjust automatically depending on
the environmental temperature.
[Operation Instructions]
Go to the
FUNCTION
page and locate
Weatherdependent
Mode, then, configure it through the
Up/Down
key , “
On
” or “
Off
”.
[Notes]
① Once it is activated, it should be deactivated manually.
② This setting will be memorized upon power failure.
③ At the “Parameter View” page, it is able to check the set point at the Weather dependent Mode.
④ When it is activated, it is allowed to set the room temperature but the set point does not take
effective. However, when it is deactivated, the unit will run according to this set point.
⑤ It can be set to “On” or “Off” no matter if the unit is in operation or not, but be activated only
when the unit is in operation.
⑥ This mode works only for the air conditioning function.
3.2.2.10 Holiday Release
In summer or high-temperature season, this function will make the unit pause to run in some
specific periods when the user is out.
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Holiday release
”, then, configure it through the Up/Down
key , “
On
” or “
Off
”.
[Notes]
① When it is activated, at the WEEKLY TIMER page, it is able to set some week day to
“Holiday release”. In this case, the “Weekly timer” in this day is ineffective unless it is set to
“Effective” manually.
② This setting will be memorized upon power failure.
3.2.2.11 Disinfection
To Next Page
Loading...
