Unit Control
54
[Notes]
① “Hot water” will take precedence only when “Water tank” is available, other it will tell
“Reserved”.
② This setting will be memorized upon power failure.
3.2.2.7 Quiet
This function can be activated when the running noise is too high.
[Note]
when this function is activated, frequency of both the compressor and the fan will go down and the
capacity of the unit will also correspondingly decrease.
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Quiet
”, then, configure it through the Up/Down key
, “
On
” or “
Off
”.
[Notes]
① It can be set to “On” or “Off” no matter whether the unit is in operation or not.
② Once it is activated, it should be deactivated manually or by Quiet Timer.
③ It will not memorized and defaulted to be off upon power failure.
④ It will be deactivated when the unit is turned off.
3.2.2.8 Quiet Timer
When running noise is too high at some specific timer periods, this function enables the unit run
quietly at this time period.
[Operation Instructions]
1. Go to the
FUNCTION
page and locate “
Quiet timer
”, then, access to the
QUIET TIMER
setting
page.
2. At the
QUIET TIMER
setting page, select “
Start time
” or “
End time
” through the Left/Right keys
and then configure the desired time through the
Up/Down
keys .
3. When the mode setting is finished, then by pressing “
Save
”, a pop-up window will pop up to
remind if you are determined to save this setting. If so, press the “
OK
” key . If not, press the
“
Cancel
” key to not save this setting.
4. When the setting is saved, the control then will back to the
FUNCTION
page and the cursor will
be where the “
Quiet timer
” option is, then by the
Up/Down
key , it can be set to be “
On
” or
“
Off
”.
To Next Page
Loading...
