Unit Control
60
or decrease the corresponding value which will be continuously changed by pressing and holding the
key. (Unless otherwise specified, all timer settings follow the similar way.)
4. When the setting is finished, save it by pressing the
Function
key no. 2 , or this setting
without being saved is ineffective.
5. When the setting has been saved, activate the “
Clock Timer
” at the
FUNCTION
page.
[Notes]
① IfWhen “Weekly timer” and “Clock timer” settings are performed at the same time, the
latter takes precedence.
② When the water tank is available, the allowed running modes include “Heat”, “Cool”,
“Heat+ hot water”, “Cool+hot water”, and “Hot water”.
③ When the water tank is unavailable, the allowed running modes only include “Heat” and
“Cool”.
④ When “Clock timer” has already been set and the concerned modes include “Hot water”,
if resetting “Water tank” from “With” to “Without”, then “Hot water” mode will be
automatically changed to “Heat”, “Cool+hot water”/ “Heat+hot water” changed to “Cool”/
“Heat”.
3.2.2.14 Temp. Timer
This function will make the unit run with certain temperature in a certain period within a day based
on the user’s actual demand.
[Operation Instructions]
1. At the homepage, by pressing the
Function
key access to the
FUNCTION
page, and then
locate where “
Temp. timer
” is, after that, press
OK
key to go to the
TEMP TIMER
setting page.
2. At the TEMP TIMER setting page, by the
Left/Right
key select the desired
parameter and then by the
Up/Down
key configure it. The configurable parameters
include “
Mode
”, “
Period 1
”, “
WT-HEAT 1
”, “
Period 2
” and “
WT-HEAT 2
”.
3. When the setting is finished, save it by pressing the
Function
key no. 2 , or this setting
without being saved is ineffective.
4. When the setting has been saved, activate the “
Temp. timer
” at the
FUNCTION
page.
To Next Page
Loading...
