Unit Control
61
[Notes]
① When “Weekly timer”, “Clock timer”, and “Temp. timer” settings are performed at the same
time, the last one takes precedence.
② This function works only when the unit is in operation.
③ The allowed running modes include “Heat” and “Cool”
④ When the start time of “Period 2” is equal to that of “Period 1”, then the set point of “Period 2”
takes precedence.
⑤ TEMP. TIMER is judged by the timer value.
⑥ During the setting, the temperature set point which is set manually always takes precedence.
3. 2.2.15 Solar kit
When the solar system is prepared, this function will decide which period to let the solar system to
run. However, if the solar system will run virtually depends on the temperature difference between the
solar panel and the water tank.
[Operation Instructions]
1. Go to the
FUNCTION
page and locate “
Solar Kit
”, and then press the or key it can
be set to “
On”,
“
Off
”, or “
Timer
”. “O
n
” means to activate the solar kit when it satisfies startup conditions;
“
Off
” means to deactivate the solar kit; and “
Timer
” means to activate the solar kit when it satisfies
startup conditions during the timing period. After that, pressing “
Enter
” at the lower left corner will go to
the “
Solar Kit
” setting page, as shown below.
2. At the “
Solar Timer
” page, locate “
Start time
” or “
End time
” through the up and down keys
and then adjust the start or stop time also through the up and down keys .
3. Then, press “
Save
” and then a dialog xo will pop up. In the dialog box, press “
OK
” to
confirm this setting, or press “
Cancel
” to cancel this setting.
4. After saving the configuration, this page will automatically back to the
FUNCTION
page with the
cursor stayed at “
Solar timer
”, and then through the up and down keys to set it to be “ON” to activate
To Next Page
Loading...
