Gree XK60

Wired Controler XK60
57
Notes:
①
If the Filter function is effectively set, the icon will light up.
②
If it is not necessary to clean the filter, no matter whether the setting is
changed or not, the unit will not restart to timing while pressing
“Enter/Cancel” button.
③
If the filter should be cleaned, under On/OFF status, the icon will
blink once every 0.5s so as to remind user to clean the filter. Press
“Function” button to set with icon flashing. Press “▲” and “▼” to
adjust pollution level, and then press “Enter/Cancel” button to activate it. If
the setting pollution level is lighter than before, the icon will keep
flashing. If the setting pollution level is more serious, the icon will
go out, and the Filter function will keep on working.
④
The only method to cancel Filter function is, when the function is set with
icon A flashing, let “00”shown at the timer area, at this time, the
accumulated time will be zero clearing.
3.18 Quiet Function Setting
Press “Function” button to set Quiet function with its icon flashing.
Press “Enter/Cancel” button to activate Quiet function.
When the quiet function is On, press “Function” button to set with
Quiet icon flashing, press “Enter/Cancel” button to cancel Quiet function.