Wired Controler XK60
67
4.2 Installation Location and Installation Requirements
(1) Do not install the wired controller in the damp place or under
direct sunlight.
(2) Do not install the wired controller close to the hi-temperature
object or place where the wired controller is likely to suffer water
spray.
(3) Do not install the wired controller directly opposite to the window
so as to avoid improper operation caused by the interference of
the neighbor’s same model wired controller.
(4) Please cut off the power supply of wires embedded in the wall.
No operation is allowed with electricity.
(5) To avoid abnormal operation caused by electromagnetic
interference or other causes, please take notice of the following
statements during wiring.
Notes：
①
Be sure the communication line is wired into the correct port, otherwise it
would result in communication fault.
②
The communication line (wired controller) and power line must be
separated with the minimal distance of 20cm, otherwise it would result in
To Next Page
Loading...
